Sharp LC-32HI5012E Service Manual page 69

7. CH Table Import
8. CH Table Export
9. Reset Hotel Mode
10. USB clone to TV
11. TV clone to USB
12. Import Welcome Logo
13. Welcome Logo [ON/OFF]
14. Menu Lock [ON/OFF]
Hotel Mode: This option will enable or disable any of the Hotel Mode options
set. To modify or make them effective this option must be ON.
Default Source: This option sets the source that will be shown when TV is powered on. Each time
TV is passed to standby and powered on again, the default source selected will be displayed.
DTV Channel Type: If Default Source selected is DTV, this
option defines if channel type is TV or Radio.
Default Prog: This option defines the default program number
(TV or Radio) when Default Source selected is DTV.
Example:
- Default Source: DTV
- DTV Channel Type: Digital TV
- Default prog: 23
TV will start in DTV TV program number 23 each time the TV set is powered on.
Default Volume: This option will set the volume level that TV will show at each
power on. User can change the volume level but it is not memorized.
Max Volume: This option defines the maximum volume level allowed. Once this value
is set, the user only can modify the volume level in the range [0 .. MAX VOLUME].
CH Table Import: This function will copy the channel table
structure copied in an USB device to the TV.
CH Table Export: This function will copy the channel table
structure from one TV to an USB device.
These functions are complementary, and the target is to avoid to do a complete installation in
each TV in the hotel. It can be used only one TV, copy channel table structure in one USB and
copy the contents in the other TV sets with the option "CH Table Import"
Reset Hotel Mode: Executing this command will provoke the
restore of all default values of the Hotel mode.
USB clone to TV: This option will copy all user TV settings stored in a USB device to one TV set
TV clone to USB: This option will copy all user TV settings stored in a TV to one USB device.
These functions are complementary, and the target is to avoid to set in each TV in the hotel all
necessary settings (picture / sound / network etc...). It is enough to adjust one TV, copy contents
in a USB with "TV clone to USB" function and put them in other TVs with "USB clone to TV".
Import Welcome Logo: This function allows to show a Logo (jpg file) on a TV start up for some
seconds. The File name should be called "Welcome.jpg" and the picture will be stored on the
TV memory. If the Logo needs to be updated it can be done by overwriting the existing one
in the TV memory. When logo is downloaded in the TV, a message must be shown; "Ok".
Welcome Logo: This command enables / disables the Welcome.
jpg picture mentioned in the previous function.
Menu Lock: This function bocks the MENU key in the remote control to prevent user
can change any undesired parameter that can be accessible from the main menu.
69