Canon XL1SA Instruction Manual page 94

Preparations
E
Turn the camera's POWER dial to VCR. Load a recorded cassette.
• Make sure the REC/SAVE tab on the cassette has been slid to REC (closed position).
Dubbing
VCR POWER
OFF
A
Tv
Av
Do not connect/disconnect any cables to/from the camera when dubbing audio or preparing to dub audio.
VCR SET UP
(see p. 26)
• Step 1 and 2 are the same operations as 2 Channel Recording.
1. Slide the INPUT SELECT switch to your input (MIC or AUDIO 1).
• When you use the AUDIO 1, select the input level from the AUDIO 1 IN of VCR SET UP of camera
menu.
2. Adjust the recording level.
3. Locate the point where you want to start audio dubbing, then press the PAUSE button.
• You can use the playback buttons on the body of the camera or the special playback functions on the
wireless controller in the same way as in playback mode.
• The camera becomes set to playback pause mode.
4. Press AUDIO DUB.
• AUDIO DUB. and
5. Press the PAUSE button on the wireless controller or play pause e/a button(and start
play on the other audio device if AUDIO 1).
• Audio dubbing starts.
• If you are using the microphone, direct your voice into the microphone.
• changes to
94
AUDIO 1 IN•• LINE
appear on the viewfinder.
.
REC
AUDIO DUB.
AV INSERT
AUDIO
DUB.
AUDIO
MONITER
ST-1 ST-2 MIX
BALANCE
SEARCH SELECT
REW PLAY FF
STOP
PAUSE SLOW 2
REC
PAUSE