Canon XL H1S Instruction Manual page 55

When an external time code signal is received, the camcorder's own time code will be
synchronized to it and the synchronization will be maintained even if you disconnect the cable
from the TC-IN terminal. However, performing any of the following actions while the cable is not
connected will cause the time code to lag slightly; the correct time code will be restored once you
reconnect the cable.
- Turning the camcorder off/on.
- Changing the position of the
- Changing the position of the
- Changing the position of the MODE SELECT or FRAME RATE switch.
If the external time code signal is incorrect or there is no input signal, the internal time code
(according to the [TIME CODE]/[COUNT-UP] settings) will be recorded on the tape instead.
If the external Genlock signal is incorrect or there is no input signal, the external time code being
recorded on tape may be incorrect.
When recording in SD mode, Time Code IN is not available if you select the 24F frame rate (the
mode will be canceled and the "TC·IN" display on the side panel will disappear).
When the camcorder is set to HD standard, Genlock synchronization is possible even if the
external Genlock signal is in SD standard. However, Genlock synchronization will not be possible
if the external Genlock signal is in HD standard but the camcorder is set to SD standard.
The phase difference between the external Genlock signal and the camcorder is initially set to 0; it
can be adjusted within the range of approx. ±0.4H (-1023 to +1023) with the [SIGNAL SETUP]
[GENLCK ADJST] setting (
Genlock synchronization is not possible when the camcorder is set to HD standard and [SDI
SPEC.] is set to [SD LOCKED].
About the Side Panel Indications
- "GENLOCK" will flash until the synchronization stabilizes and will stay on once the phase
synchronization has stabilized.
- "TC·IN" and "TC·OUT" indicate, respectively, that Time Code IN or Time Code OUT
synchronization is available.
- "EXT- LOCK" indicates that the camcorder has locked on to an external time code signal.
dial to or from
/ (card/tape) switch.
)
133 .
.
55