NEC N8190-7160 User Manual page 87

RemovePersistentBinding
This command removes persistent binding between an FC target and a SCSI Bus and target.
The binding to be removed can be to a target WWPN address, target WWNN address, or target
D_ID.
Syntax
RemovePersistentBinding <WWPN> <BindType> <ID> <SCSIBus> <SCSITarget>
Parameters
<WWPN>
The WWPN address of the adapter.
<BindType>
P = Remove binding by WWPN address.
N = Remove binding by WWNN address.
D = Remove binding by D_ID.
<ID>
The type of ID based on <BindType>:
Target WWPN address if <BindType> = P
-
Target WWNN address if <BindType> = N
-
Target D_ID if <BindType> = D
-
<SCSIBus>
The bus number of the SCSI device.
<SCSITarget>
The target number of the SCSI device.
SetPersistentBinding
This command sets a persistent binding between an FC target and a SCSI Bus target.
The binding can be to a target WWPN address, target WWNN address, or target D_ID.
Syntax
SetPersistentBinding <WWPN> <Scope> <BindType> <TargetId> <SCSI Bus> <SCSI Target>
Parameters
<WWPN>
The WWPN address of the adapter.
<Scope>
P = Permanent binding (survives reboot).
I = Immediate binding.
B = Binding is both permanent and immediate.
<BindType>
P = Enable binding by WWPN address
N = Enable binding by WWNN address
D = Enable binding by D_ID
<TargetId>
If BindType = P, Target WWPN address
If BindType = N, Target WWNN address
If BindType = D, Target D_ID
<SCSIBus>
The bus number of the SCSI device.
<SCSITarget>
The target number of the SCSI device.