7.23. Remove the stand brackets
and rear mounting metals
1. Remove the plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered)
with the plasma panel surface facing downward.
2. Remove the stand brackets (left, right) fastening screw
(×1
each).
3. Remove the rear mounting metals (left, right) fastening
screws (×4
each).
4. Remove the stand brackets and rear mounting metals.
5. Remove the fastening screws (×4
6. Remove the stand brackets from rear mounting metals.
7.24. Remove the Plasma panel sec-
each).
25
tion from the Cabinet assy
(glass)
1. Remove the stand brackets (left, right) fastening screw
(×1
each).
2. Remove the cabinet assy and the plasma panel fastening
, ×12
screws (×6
3. For leaving the plasma panel from the front frame, pull the
bottom of the cabinet assy forward, lift, and remove.
).