Table of Contents
Advertisement
3.11
Loading Paper
1.
Turn on the power.
2.
Pull the cover open lever forward and open the paper cover.
3.
Lock the paper damper when using label paper or thick paper.
4.
Load the paper roll so that the printable side of the paper is facing down, as shown
by arrow A.
5.
Pull a few cm of paper straight out in the direction of arrow B.
6.
Close the paper cover until you hear a click. Paper is fed and cut automatically (by
the factory setting).
CAUTION
Always use the specified types of paper rolls.
Confirm that the paper roll is set correctly.
If the paper is skewed and not coming straight out of the paper cover, open it and
straighten the paper.
Always pull a few cm of paper straight out of the printer if you open the paper cover
while paper is loaded.
Press on the center of the paper cover to close it securely.
Be careful of paper cuts while loading the paper.
Do not touch the print head, manual cutter, or auto cutter while the paper cover is
open. Doing so may cause a burn or cut.
Refer to 5.3 Manual Setting of Memory Switches
— 38 —
Advertisement
Table of Contents
