Weslo pursuit 2.9 User Manual page 8

6. While another person hold the Console (5) near
the Upright (2), connect the console wire to the
Upper Wire Harness (30).
Insert the excess wire downward into the
Upright (2).
Tip: Avoid pinching the wires. Slide the
Console (5) onto the Upright (2).
7. Position the Handlebar (3) inside the hinged
bracket on the Upright (2).
Attach the Handlebar (3) with the Handlebar
Cover (18), the Handlebar Spacer (21), and the
Adjustment Handle (17).
Connect the console pulse wires to the Pulse
Wires (57). Insert the excess wires into the
Handlebar (3).
8. Identify the Left Pedal (10), which is marked
with an "L."
Using an adjustable wrench, firmly tighten the
Left Pedal counterclockwise into the left arm of
the Crank (12).
Tighten the Right Pedal (not shown) clockwise
into the right arm of the Crank.
IMPORTANT: Tighten both pedals as firmly
as possible. After using the exercise cycle
for one week, retighten the pedals. For best
performance, the pedals must be kept tight-
ened.
9. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly
is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
All manuals and user guides at all-guides.com
8
6
5
Console
2
7
57
Console
Pulse Wires
8
10
Wire
30
Avoid pinching
the wires
3
2
18
21
17
12