Weslo pursuit 2.9 User Manual page 11

3. Select a mode.
Scan mode—To
select the scan
mode, repeatedly
press the MODE
button until the word
SCAN appears in
the display.
Time, speed,
distance, or calorie
mode—To select
one of these modes
for continuous dis-
play, repeatedly
press the MODE
button until the
desired selection appears in the display. Make
sure that the word SCAN does not appear in
the display.
Note: To reset the time, distance, or calorie mode,
first make sure that the word STOP appears in the
display. Next, press the MODE button until the let-
ters TMR, DST, or CAL appear in the display.
Make sure that the word SCAN does not appear.
Then, press the RESET button.
4. Begin pedaling and follow your progress with
the display.
As you exercise, the console will display the
mode(s) that you select. If you have set a workout
goal, a tone will sound for several seconds when
you reach your goal.
All manuals and user guides at all-guides.com
11
5. Measure your heart rate, if desired.
If there are sheets of clear plastic on the metal
contacts of the handgrip pulse sensor, peel off
the plastic. Place your hands on the handgrip
pulse sensor, with your palms on the contacts.
Avoid moving your hands. When your pulse is
detected, your heart rate will be shown.
For the most accurate heart rate reading, continue
to hold the handgrips for about 30 seconds.
If your heart rate is not shown, make sure that
your hands are positioned as described. Avoid
moving your hands excessively or squeezing the
metal contacts too tightly. For optimal perfor-
mance, periodically clean the metal contacts using
a soft cloth; never use alcohol, abrasives, or
chemicals to clean the contacts.
6. When you are finished exercising, the console
will automatically turn off.
If the pedals do not move for a few seconds, the
word STOP will appear in the display, and the con-
sole will pause.
The console has an "auto-off" feature. If the pedals
do not move and the console buttons are not
pressed for a few minutes, the power will turn off
automatically to save the batteries.
Metal
Contacts