Read through each step carefully and follow the proper order. We recommend that, where possible, all items are assembled near to the EP23627 / EP23628 / EP23629 area in which they will be placed in use, to avoid moving the product unnecessarily once assembled.
Page 3
IMPORTANT SAFETY INSTRUCTIONS ..........................5 WARNING 1.0 PACKING LIST….. …………………………......………..………………………………........7 1.1 DIMENSIONS ................................ 8 These instructions should be carefully read before installation and retained by the user. The booklet must be kept and delivered to the new user in case of disposal of the heater. The Manufacturer reserves the right to vary 2.0 ELECTRICAL INSTALLATION NOTES ..........................
Page 4
18. Always unplug appliance when not in use. 19. Do not operate this appliance with a damaged cord or plug after the appliance malfunctions, has been dropped o damaged in any manner. Return appliance to authorized service facility for examination, 「...
2.1 GENERAL INSTRUCTIONS 3.1 UNPACKING AND TESTING APPLIANCE WALL Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the appliance 心 CAUTION - Some parts of this product can become very hot and cause burns. Particular attention has operates properly by plugging the power supply cord into a conveniently located 120 Volt grounded outlet.
Heater Vent Main Power But t on Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate. 4.1 MAIN POWER BUTTON Control The Main Power Button is located on the upper right (left) of the fireplace as illustrated. Press indicator to turn on Panel the appliance, press the other side turns it off.
4.3 REMOVE CONTROL 、 ` Control Flame speed. 回 FLAME +Move the batter y 's trans p arent insulatin g p iece awa y before usin g . S Settings: (Vl-V2-V3-V4-VS) Flame speed from Vl to VS . VS is the fastest SPEED setting.
Leave adequate space around the unit. Remove the blocked completely. blockage, on or in front of the air outlet. Message or e-mail us at: cs.us@costway.com 1. The heater system is overheated. Check the air inlet and outlet. Turn off the power Temperature Limit thermostat is switch and unplug it.
This product is not intended to be used as a primary heat source. It is for supplemental heating purposes only. Thank you for purchasing this product! If you have questions about assembly or operation of this product, are missing parts, or if the product is damaged, please contact us via Amazon Message or e-mail us at: cs.us@costway.com...
Need help?
Do you have a question about the EP23627 and is the answer not in the manual?
Questions and answers