ITC Stow & Glo 86475-30-BL-04-001 Installation Instructions

Assist handle

Advertisement

PARTS NEEDED:

Stow & Glo Handle
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
* The Stow & Glo handle should be installed into a solid support structure or will run the risk of being pulled out of the wall.
* The Stow & Glo handle should never be left in the operating position while traveling. Leaving the handle in the operating position while
traveling will void the warranty.
* When installing the handle with screws make sure the pilot hole is properly sized and accommodate for wall thickness when selecting a
screw length.
* CAUTION: This handle is only to be used in assisting a person when entering or exiting the RV. Caution should always be used when
entering or exiting an RV.
1.
Determine the installation location for your handle*, making sure there is a solid support or backer material behind the location to
support the handle. If there is no backer than you may need to use a bolt, large washer, nut and plate (not provided).
2
Press to
door jam 1
3
*Use a level to ensure end caps are vertically aligned
2.
Note that the handle measures 27.25" from the top of one cap to the
bottom of the other. It is recommended that a 1/8" drill bit be used
when using 1/4" screws, to drill the pilot holes. Install screws in top end
cap first, beginning with the bottom right screw 2 . Proceed with the
bottom right screw 3 on the bottom end cap. It is recommended that
the handle be in the closed position when installing the top hinge and
the open position when installing the bottom hinge.
Phone: 616-396-1355 • www.itc-us.com • sales@itc-us.com • Doc #710-00160 • Revision 1: 01/20/20
Stow & Glo Assist Handle Installation Instructions
(Part #'s: 86475-30-BL-04-001)
1/4" Pan Head Screws, Coated for
Exterior Installation
(not provided -
recommend four per end cap)
3030 Corporate Grove Dr • Hudsonville • MI • 49426

TOOLS NEEDED:

Power Drill w/ 1/8" Drill Bit
(if screws are used for installation)
Closed
Position
2
Silicone Sealant
(Optional - not supplied)
1
Open
Position
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Stow & Glo 86475-30-BL-04-001 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ITC Stow & Glo 86475-30-BL-04-001

  • Page 1 3030 Corporate Grove Dr • Hudsonville • MI • 49426 Phone: 616-396-1355 • www.itc-us.com • sales@itc-us.com • Doc #710-00160 • Revision 1: 01/20/20...
  • Page 2 Stow & Go Assist Handle Installation Instructions To create a seal around the screw holes, ITC recommends using a silicone sealant in pre-drilled holes before installing screws. To operate the handle, swing the handle to the right 90°. To replace to the stowed position, gently pull up on the handle and rotate the handle to the left until secure.

Table of Contents