Advertisement
502.601 Hydraulic Punch Instructions
Operating Instructions
1. Several parts will be needed to complete the punching process.
Use the chart below to select the correct punch, die, draw stud
and spacers.
2. Drill an 11mm wide leading hole through the steel plate at the
desired punch point.
3. Screw the ¾" draw stud into the puncher head. Put
the appropriate space and female die into place.
Note: if using the 3/8" draw stud, then both draw
studs and all three spaces must be used together.
4. Insert the draw stud through the lead hole. Screw the
male die end of the draw stud until the steel plate is
secure between both dies. (see illustration)
5. Open the release valve on the pump by turning the knob
counter-clockwise. Connect the pump hose to the puncher
and secure the couplers firmly.
Punch
Ø hole
(mm)
Dies
1/2"
21.8
3/4"
27.3
1"
34.1
1–1 1/4"
42.7
1–1 1/2"
48.7
2"
60.5
Step 1
Primary Perforation
Drill
Punch
Setting Thread
Ø 11mm
1/2"
Draw Stud
3/8"
3/8"
3/4"
1
Step 2
Spacer
L
M
S
-
-
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ITC 502.601
Summary of Contents for ITC 502.601
- Page 1 502.601 Hydraulic Punch Instructions Operating Instructions 1. Several parts will be needed to complete the punching process. Use the chart below to select the correct punch, die, draw stud and spacers. 2. Drill an 11mm wide leading hole through the steel plate at the desired punch point.
- Page 2 Refer to the cutting capacity of this tool, please select the correct plate for you applications Inform ITC in case of any abnormalities or malfunctions of the product. Receipt and warranty card are required for warranty services Suggested working temperatures: -10 to ~40°C ...
- Page 3 Limited Warranty Limited warranty of ITC goods are valid for a period of ONE year from the date of purchase This warranty is subject to the exclusions and limitations described below: 1. This warranty does not cover damages of products which are NOT installed, operated, used and maintained in accordance with written instructions 2.
Need help?
Do you have a question about the 502.601 and is the answer not in the manual?
Questions and answers