Installation Of Burner Cap Assembly; Electric Ignition Surface Burners - Frigidaire PLEF398CCB Installation Instructions Manual

30" GAS RANGE INSTALLATION INSTRUCTIONS
Operation of Surface Burners

6. Installation of Burner Cap Assembly

Your range is equipped with any combination of the sealed
burners. Refer to the chart to find your surface burner and
surface burner cap configuration. Be sure to place the correct
burner cap at on all four surface burners.
Install the parts shown below at all four surface burner
locations:
1st - Install the surface burner pans (if equipped); 2nd -install
the surface burner heads; 3rd - install the surface burner caps
and 4th; install the burner grates.
(For Models with Sealed Top Burners)

7. Electric Ignition Surface Burners

Operation of electric igniters should be checked after range
and supply line connectors have been carefully checked for
leaks and range has been connected to electric power.
a. To check for proper lighting, push in and turn a surface
b. The surface burner should light when gas is available to
c. Visually check that burner has lit. Once the burner lights,
d. There are separate electrodes (igniters) for each burner.
Note: Knob styles may vary from those pictured below.
c.
6
burner knob counterclockwise to the LITE position.
You will hear the igniter sparking.
the top burner. Purge air from supply lines by leaving
knob in the LITE position until burner ignites.
burner should light within four (4) seconds in normal
operation after air has been purged from supply lines.
the control knob should be turned out of the LITE position.
Try each knob separately until all burner valves have
been checked.
If burner goes out, reset control to OFF.
Each