Frigidaire PLEF398CCB Installation Instructions Manual

30" gas range
Hide thumbs Also See for PLEF398CCB:

Advertisement

30" GAS RANGE INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
If the information in this manual is not followed
exactly, a fire or explosion may result causing property
damage, personal injury or death.
FOR YOUR SAFETY:
— Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
— Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
Clearances and Dimensions
1. Location—Check location where
the range will be installed. Check
for proper electrical and gas
supply, and the stability of the
floor.
2. Dimensions that are shown must
be used. Given dimensions
provide minimum clearance.
Contact surface must be solid
and level.
P/N 316259330 EN_SP (0309)
(For Models with Sealed Top Burners)
Provide Proper Fuel Type
Before Proceeding: Your range is preset to operate on natural gas only. Some
models are shipped convertible with parts and conversion instructions supplied.
Other models have a LP/Propane Conversion Kit available through your dealer.
DO NOT attempt to convert this range to LP/Propane settings without
the proper LP/Propane conversion kit provided with the range or obtained from your
dealer. Follow all instructions provided with the conversion kit.
1
Note: For appliances installed in the
state of Massachusetts see page 2.
30-1/8"
Español - Páginas 9-16

Advertisement

Table of Contents
loading

Summary of Contents for Frigidaire PLEF398CCB

  • Page 1 (For Models with Sealed Top Burners) 30-1/8" Provide Proper Fuel Type Before Proceeding: Your range is preset to operate on natural gas only. Some models are shipped convertible with parts and conversion instructions supplied. Other models have a LP/Propane Conversion Kit available through your dealer.
  • Page 2: Important Notes To The Installer

    1. Keep these instructions with your owner's guide for future reference. IMPORTANT SAFETY INSTRUCTIONS Installation of this range must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code ANSI Z223.1—latest edition when installed in the United States.
  • Page 3: Before Starting

    1. Anti-Tip Bracket Installation Instructions Important Safety Warning To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed anti-tip bracket and screws packed with the range. Failure to install the anti-tip bracket will allow the range to tip over if excessive weight is placed on an open door or if a child climbs upon it.
  • Page 4: Seal The Openings

    (For Models with Sealed Top Burners) 3. Seal the openings. Seal any openings in the wall behind the range and in the floor under the range after gas supply line is installed. 4. Connect the range to the gas supply.
  • Page 5 Make sure service shut-off valve on pressure regulator is in "ON" position. g) Check for leaks. Turn the gas supply on to the range and use a liquid leak detector at all joints and conduits to check for leaks in the system.
  • Page 6: Installation Of Burner Cap Assembly

    Operation of Surface Burners 6. Installation of Burner Cap Assembly Your range is equipped with any combination of the sealed burners. Refer to the chart to find your surface burner and surface burner cap configuration. Be sure to place the correct burner cap at on all four surface burners.
  • Page 7: Operation Of Oven Burners And Oven Adjustments

    Operation of Oven Burners and Oven Adjustments 9. Electric Ignition Burners Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. The oven burner is equipped with an electric control system as well as an electric oven burner igniter.
  • Page 8: Before You Call For Service

    When ordering parts for or making inquires about your range, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your range. Your serial plate also tells you the rating of the burners, the type of fuel and the pressure the range was adjusted for when it left the factory.

Table of Contents