Advertisement
ll heat lamps are offered in 120-, 208-, and 240-volt. 120-volt operation for display lamps only. Please refer to the catalog for all
model numbers. See the legend below for details on the model number.
Model number description:
prefix
length
RHHL -
18
Legend:
-H = high watt
-L = incandescent lights
-R = remote control
DIMENSIONS FOR UNIT WITHOUT LIGHTS:
DIMENSIONS FOR UNIT WITH LIGHTS:
To conform to national and local electrical codes, please consult a licensed electrical contractor for proper installation. Failure to
do so may result in personal injury, fire, damage to the unit, or code violations.
Please note: Heat lamp is NOT intended to be wired to cord & plug.
Optional Control Switch Box Connection
(When ordering a heat lamp with a remote, the main unit does not contain any switches.)
Following UL, NEC and local codes, install a copper supply wire temperature rated no lower than 90C to the control box. Eagle
Group supplies a 7/8˝ and 1-1/8˝ knockout on the sides of the aluminum housing and 6˝ long, 12-gauge pigtails with a separate ground
screw. Control boxes are sized according to the heat lamp selected during ordering. The control box is made of 6063 aluminum and is 2-1/2˝
high x 3˝ deep. The control box should be mounted away from any heat or steam source and not in hot zones as marked in the
illustration below. Note the 18˝ dimension on the sides of the heat lamp should be maintained for the front and rear as well.
Note: Do not connect a circuit operating at more than 150 volts to ground.
MOUNT CONTROL BOX OUTSIDE THE FOLLOWING RE SHOWN:
OPER TING M NU L ND INSTRUCTIONS
END MODEL SPECIFIC TIONS:
volts
watt type
lights
- 120
-
H
-
L
front view
front view
ELECTRIC L REQUIREMENTS
remote control
-
R
W RNING
front view
2
end view
end view
Advertisement
