Panasonic KX-TG2712 Operating Instructions Manual page 33

Programmable settings
Problem
The display is in a language I
cannot read.
I cannot register a handset to a
base unit.
Battery recharge
Problem
The handset beeps and/or
flashes.
I fully charged the batteries, but
– still flashes, or
– the operating time seems to
be shorter.
Making/answering calls, intercom
Problem
is flashing.
Noise is heard, sound cuts in
and out.
The handset does not ring.
The base unit does not ring.
I cannot make a call.
I cannot make long distance
calls.
For assistance, please visit http://www.panasonic.com/help
PNQX6299ZA_0628_v0.1.2.pdf
Cause/solution
R Change the display language (page 12).
R The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 21).
Cause/solution
R Battery charge is low. Fully charge the batteries (page 9).
R Clean the battery ends (
with a dry cloth and charge again.
R It is time to replace the batteries (page 9).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 21).
R You are using the handset or base unit in an area with
high electrical interference. Re-position the base unit and
use the handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
R The ringer volume is turned off. Adjust the ringer volume
(page 14, 20).
R The ringer volume is turned off. Adjust the ringer volume
(page 15).
R The dialing mode may be set incorrectly. Change the
setting (page 13).
R Make sure that you have long distance service.
33
Useful Information
, ) and the charge contacts
2013/06/28
33
16:49:36