Canon OPTURA30 Instruction Manual page 145

Message
CANNOT TRIM
READJUST TRIMMING
PRINTER ERROR
PRINT ERROR
HARDWARE ERROR
RECHARGE THE
PRINTER BATTERY
COMMUNICATION
ERROR
CHECK PRINT
SETTINGS
PRINTER IN USE
PRINTER WARMING
UP
PAPER LEVER ERROR
PRINTER COVER OPEN
NO PRINTHEAD
You attempted to trim an image with an image size of
160 × 120, or an image not recorded in the 4:3 ratio.
You changed the print style after you set the trimming settings.
Cancel printing. Turn off the printer and turn it back on. Check
the printer status.
Cancel printing, disconnect the USB cable and turn off the printer.
After a while, turn the printer back on and reconnect the USB
cable. Check the printer status.
When you are printing using the
settings.
Cancel printing. Turn off the printer and turn it back on. Check
the printer status.
The printer battery is depleted.
The printer is experiencing a data transmission error. Cancel
printing, disconnect the USB cable and turn off the printer. After a
while, turn the printer back on and reconnect the USB cable.
When you are printing using the
settings.
Or, you attempted to print from a memory card that contains a
large number of images. Reduce the number of images.
The print setting cannot be used for printing with the
button.
The printer is in use. Check the printer status.
Printer is warming up. If the message does not disappear after a
few seconds, check the printer status.
Paper lever error occurred. Adjust the paper selection lever to the
proper position.
Close the printer cover securely.
No print head is installed in the printer or print head is defect.
Refer to the instruction manual of your printer.
Explanation
button, check the print
button, check the print
E
145