Hitachi NW-80AS User Manual page 37

Adjustment of the position and height of the washing cap
調整洗衣蓋的位置高度
In "Wool" program
• The installation position (height) of the washing cap is to be determined by the types, sizes, and thickness of the laundry.Please install
the washing cap at a height where it could press against the laundry slightly.
• There is a sign of protrusion on the interior wall of the washing
which can be used as reference at the time of installation
• For light and thin laundry such as blouses, towels can be put into the
&
washing spinning basket to adjust the height of the laundry to
prevent unbalanced laundry.
In "Blanket" program
1
Put the washing cap into washing & spinning basket, hold the center circle, and pull it right beneath the
balance ring.
•
• Do not clip the laundry when installing the washing cap.
It is prohibited to install the washing cap aslant. In addition, the washing cap is
prohibited from being used in programs other than the "Blanket" "Ｗ Ｗ Ｗ Ｗ W ool" program.
嚴禁傾斜安裝洗衣蓋。另外，除「被毯」、「毛絨」程序外，嚴禁在其它程序中使用洗衣蓋。
Prohibited • Otherwise the splashed water drop or the washing cap bounced out may cause body injury or
禁止
damage of the washing machine.
以免水滴飛濺或洗衣蓋飛出造成人身傷害或洗衣機損壞。
• When keeping the washing cap, please prevent it from deforming.
保管洗衣蓋時，請注意防止其變形。
• The washing cap is a consumable good. You can purchase it at authorized dealers.
Refer to page 56 for the optional parts.
洗衣蓋屬於消耗品，若有損壞請到指定的商鋪購買。
另售部品 56
Taking out the washing cap
洗衣蓋的取出方法
1
Push the washing cap
down.
將洗衣蓋向下壓。
Push
&
spinning basket, indicating where the installation position shall be,
washing cap
washing cap
Attention 注意
2
As shown in the figure hold
on to the center part and
bend it to the arrow direction.
如圖抓住中圈，將洗衣蓋向
箭頭方向彎曲
Bend
washing
Washing
load
water level
Less than 1.5kg
45~30L
1.5kg
balance ring
central circle
3
Pull the washing cap out.
然後順勢將洗衣蓋拉起，取出。
Pull the washing
cap out
37