Philips FW-P78 Manual page 13

All manuals and user guides at all-guides.com
– Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.
To start the demonstration mode
• Press and hold Ç (on the system only)
for 5 seconds when the system is in
standby mode.
™ The demonstration will begin.
Easy Set
EASY SET allows you to store all available
radio stations and RDS stations (if
applicable) automatically.
1 Press and hold STANDBY ON (on the
system only) for 5 seconds ; when the
system is in standby or demonstration
mode.
™ "EASY SET" will be displayed,
and followed by "TUNER" and then
"AUTO".
™ EASY SET will start searching for all
RDS radio stations with sufficient
signal strength and then followed by
radio stations on FM and MW band
respectively. Weak RDS radio
stations may be stored in later
presets.
™ All available RDS and radio stations
with sufficient signal strength will be
stored. Up to 40 presets may be
stored.
pg 01-31/P75-P78/34-Eng 13
2 The system will proceed to set the RDS
Switching the system ON
time automatically with the stored RDS
• Press CD, TUNER, TAPE or AUX.
preset station.
• If no RDS station is available in the first
You can also switch on the system by
preset station, the program will exit pressing any one of the CD DIRECT PLAY
automatically. buttons.
™ After a radio station is found,
"EASY SET" will be displayed
Switching the system to
and followed by "TIME"
standby mode
• When searching RDS time;
• Press STANDBY ON or B on the
™ "SEARCH RDS TIME" will be
remote control.
displayed.
™ The system will switch to standby
™ When RDS time is read, "RDS
TIME" will be displayed. The
™ (for model FW-P78 only)
current time will be displayed for 2
seconds and stored automatically.
Notes:
– EASY SET will start with the RDS
station, if there are still presets
available, it will continue to store the
Selecting the Source
FM and MW bands respectively.
• Press the respective source selection
– When EASY SET is used, all previously
button: CD, TUNER, TAPE or AUX.
stored radio stations will be replaced.
™ The display indicates the selected
– The last preset radio station or the first
available RDS station will appear on the
display when EASY SET is completed.
Note:
– If RDS station does not transmit RDS
– For an external source, make sure you
time within 90 seconds, the program
have connected the audio left and right
will exit automatically and the display
OUT terminals of the external
will show " NO RDS TIME ".
equipment (TV, VCR, Laser Disc player,
DVD player or CD Recorder) to the AUX/
CDR IN terminals.
OPERATING THE SYSTEM
Selecting the Equalizer
Display
You can select the desired equalizer display
for the system. You must not press the DSC
button on the system before using the JOG
control.
• Adjust the JOG control to select the
desired Equalizer Display, NORMAL,
TOP DOWN, or NITE MODE.
™ The selected display will be shown.
NORMAL Display
mode.
PROGRAM
REPEAT TIMER
NEWS T.A. AM MW
About five seconds later, the system
will go into an energy saving mode if
the demonstration mode has been
disabled.
TOP DOWN Display
PROGRAM
REPEAT TIMER
AM MW
NEWS T.A.
source.
NITE MODE Display
PROGRAM
REPEAT TIMER
NEWS T.A. AM MW
Note:
– In NITE MODE, all lights will be
switched off and the display brightness
will be dimmed.
2/22/00, 7:29 PM
STEREO
BACK
REC
FRONT HSD
FM LW
60Hz 8KHz
250Hz 500Hz 1KHz 2KHz 4KHz
STEREO
REC BACK
FM LW FRONT HSD
60Hz 250Hz 500Hz 2KHz 4KHz 8KHz
1KHz
STEREO
REC BACK
FRONT HSD
FM LW
60Hz
250Hz 500Hz 1KHz 2KHz 4KHz 8KHz
13
3139 116 19561