Related Manuals for CH Hanson PALMGREN 9661616
Summary of Contents for CH Hanson PALMGREN 9661616
- Page 1 Operating Instructions & Parts Manual 50 Ton Electric Hydraulic Press Model 9661616 9643571.01...
- Page 2 PLEASE READ AND SAVE THESE INSTRUCTIONS. READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 3: Getting Started
GETTING STARTED Package Contents: Pipe holders Save this manual Frame with cylinder You will need this manual for the safety warnings and precau- Hydraulic pump assembly tions, assembly instructions, operating and maintenance procedures, parts lists and diagrams. Keep your invoice with this Replacement rubber o-rings manual. -
Page 4: Safety Rules
SAFETY RULES Preparing the work area for your job • Do not use this machine in dangerous environments. Do not Completely read and understand this use it in damp or wet locations. Do not expose it to rain. owner’s manual before assembly or tool operation. -
Page 5: Specifications
• Do not use the Model 9661616 Hydraulic Press for any use ASSEMBLY/INSTALLATION other than its intended application. Improper use of this Power source tool revokes and voids any real or implied warranty. The manufacturer is not responsible for any injury that may result •... - Page 6 NOTE: The Model 9661616 Hydraulic Press weighs 507 lbs. Be Machine dimensions certain any machine or devices used to lift the press are capable of handling this weight. If manually lifting, ensure that enough people are performing the lift. Ensure sufficient space is available for the press. See Machine Dimensions.
-
Page 7: Operation
OPERATION Extract the support pin as shown below. Always wear safety glasses complying with U.S. ANSI Z87.1 before beginning any power tool operation. Do not operate this machine before properly lubricating the machine. Failure to lubricate the machine before using can cause damage to the machine. -
Page 8: Troubleshooting Guide
TROUBLESHOOTING GUIDE Symptom Possible Cause(s) Corrective Action Ram does not move • Low oil condition • Fill oil • Not enough pressure • Check motor Ram does not press Cylinder valve not closed Close cylinder valve Motor does not run Power disconnected Check on/off switch and circuit breaker... -
Page 9: Maintenance/Repair
MAINTENANCE/REPAIR The machine’s functional parts To properly operate the Model 9661616 Hydraulic Press, you Before any maintenance is performed, ensure all pressure has must familiarize yourself with all of the machine’s controls. been released. Daily • General visual inspection-check for any visible damage or missing parts •... -
Page 10: Electrical Schematic
MAINTENANCE/REPAIR - CROSS SECTION OF PISTON Item No. Description Item No. Description Oil Vat Pressurize Ring Stopcock Pressurize Ring Piston Ring Pressurize Ring Pressurize Ring Vat Cover Piston Shaft Pressurize Ring Pressurize Ring Flange ELECTRICAL SCHEMATIC... -
Page 11: Hydraulic Schematic
HYDRAULIC SCHEMATIC... - Page 12 PALMGREN WARRANTY C.H. Hanson / Palmgren warrants their products to be free of defects in material or workmanship. This warranty does not cover defects due directly or indirectly to misuse, abuse, normal wear and tear, failure to properly maintain the product, heated, ground or otherwise altered, or used for a purpose other than that for which is was intended.