Table of Contents
Advertisement
Construction, equipment installed
and safety devices
Robust steel frame, with 4 legs (adjustable in height).
18/10 chrome-nickel steel outer panelling and tank.
The water is heated by a tubular stainless steel burner,
which is resistant to thermal and mechanical stress.
The pilot burner has adjustable injector.
The combustion chamber and flues are made of elec-
tro-galvanised steel sheeting.
The temperature is set using the safety taps provided.
It goes from low (minimum) to high (maximum) through
a range of easily selectable intermediate levels.
Location
The appliance should be installed in a well ventilated
room, and under a range hood.
The appliance can be installed on its own or alongside
other equipment.
If the appliance is to be installed near inflammable wal-
ls, a minimum distance of 50 mm. around the sides and
back should be allowed.
If this is impossible, take proper steps to ensure the in-
stallation is safe, such as fitting tiles or heat-reflecting
material to the walls
Before connecting up the appliance to the gas supply,
check on the data plate that the appliance is fitted for
the type of gas available.
If not, consult paragraph "Running the appliance on
other types of gas", page 11.
Legal and technical requisites
During assembly, the following legal and technical re-
quisites should be adhered to:
- relevant national legislation;
- local building and fire safety regulations;
- worksheet "Technical rules for installing gas";
- worksheet "Technical rules for LP gas";
- worksheet "Gas installations in industrial kitchens";
- industrial injury legislation;
- local Gas Board regulations;
- current CEI regulations.
013 - 03 - Gas pasta cooker
OPERATING INSTRUCTIONS
INSTALLATION
Assembly, installation and maintenance, i.e.: assembly,
connecting the gas supply, checking power rating,
transforming or adapting the appliance to run on other
types of gas, and commissioning, must all be done by
contractors authorised by the local Gas Board in accor-
dance with local and national legislation.
Before doing anything else, seek advice from your Gas
Board.
Installation procedure
To level the appliance correctly, adjust the height of the
four legs.
Gas connection
T h e R 1 / 2 " g a s o f f - t a k e f o r m o d e l A G B 5 2 7 / W P ,
AGB 529/WP and R 3/4" for model AGB 448/WP,
AGB 450/WP, AGB 055/WP, AGB 057/WP can either be
permanently fixed to the mains or made detachable
using a standard adaptor.
If flexible hose is used, it must be in stainless steel.
After completing connection, check for leaks using a
special leak-detector spray.
Plumbing connection
A rigid or flexible pipe may be used for connection to
the water supply.
The inlet pipe has a 12 mm diameter.
Gas venting
These appliances are A construction type, thus no gas
venting is required.
For advice on ventilating the premises where the ap-
pliance is installed, observe current regulations.
9
Advertisement
Table of Contents
