List Of Messages - Canon MV MVX30i Instruction Manual

List of Messages

Message
SET THE TIME ZONE,
DATE AND TIME
CHANGE THE
BATTERY PACK
THE TAPE IS SET FOR
ERASURE PREVENTION
REMOVE THE
CASSETTE
CHECK THE INPUT
CONDENSATION HAS
BEEN DETECTED
TAPE END
CHECK THE CASSETTE
[REC MODE]
CHECK THE CASSETTE
[AUDIO MODE]
CHECK THE CASSETTE
[BLANK]
HEADS DIRTY, USE
CLEANING CASSETTE
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED
COPYRIGHT PROTECTED
DUBBING RESTRICTED
Memory Card Related Messages
Message
NO CARD
THE CARD IS SET FOR
ERASURE PREVENTION
NO IMAGES
CARD ERROR
CARD FULL
NAMING ERROR
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the
time zone, date and time.
Battery pack is exhausted. Replace or charge the battery
pack.
Cassette is protected. Replace the cassette or change the
position of the protect switch.
Camcorder stopped operating to protect the tape. Unload
and reload the cassette.
DV cable or USB cable is not connected, or the connected
digital device is turned off.
Condensation has been detected in the camcorder.
Tape reached the end. Rewind the tape or replace the
cassette.
You attempted to perform audio dubbing on a tape
recorded in a mode other than the SP mode.
You attempted to perform audio dubbing on a tape
recorded in 16-bit or 12-bit 4-channel sound.
You attempted to perform audio dubbing on a tape with a
blank section.
Video heads are dirty. Clean the video heads.
You attempted to play back a copyright protected tape.
You attempted to dub a copyright protected tape. May also
appear when an anomalous signal is received during analog
line-in recording, or during analog-digital conversion of a
copyright protected tape.
Memory card not is inserted into the camcorder.
SD Memory Card is set for erasure prevention. Replace the
card or change the position of the protect switch.
No images are recorded on the memory card.
A memory card error occurred. The camcorder cannot record
or play back the image.
The error may be temporary. If the message disappears after
4 seconds and " " flashes red, turn the camcorder off,
remove the card and reinsert the card. If "
green, you can continue recording/playback.
No remaining capacity on the memory card. Replace with
another card or erase images.
File or folder number has reached the maximum value.
Explanation
Explanation
" changes to
E
18
11
149
14
86
147
–
88
88
88
147
84
84
93
93
–
–
–
96
143