Montgomery Ward 769117 Instruction Manual page 5

Installation (cont.)
A. Installation in a double-hung window
1. Open the window and cut the foam seal (with
adhesive) to length and attach it to the bottom
and sides of the window opening.
2. Set the window slider kit on the bottom of the
window opening. Adjust the length of the slider
kit according to the width of window and
secure the length with a bolt (see page 6).
3. If the window opening is less than 26½" wide,
use a saw to cut the slider kit (piece with the
exhaust hole) to fit the window opening.
4. Cut the foam seal (with adhesive) to length and
attach it to the window sash.
5. Close the window securely on the window kit
and secure with the security bracket, if desired.
6. Cut the foam (without adhesive) to length and
attach it to seal the open gap between the
inside window and outer window.
B. Installation in a sliding window
1. Open the window and cut the foam seal (with
adhesive) to length and attach it to the window
frame.
2. Set the window slider kit vertically on the
bottom of the window, against the frame.
Adjust the length of the slider kit according
to the height of the window and secure the
length with a bolt (see page 6).
3. If the window opening is less than 26½" tall, use
a saw to cut the slider kit (piece with the
exhaust hole) to fit the window opening.
4. Cut the foam seal (with adhesive) to length and
attach it to the window sash.
5. Close the window securely on the window kit
secure with the security bracket, if desired.
6. Cut the foam (without adhesive) to length and
attach it to seal the open gap between the
inside window and outer window.
8
foam seal
security
bracket
2
screws
foam seal
foam seal
slider
kit
foam seal
foam
seal
Wards.com
INSTALL THE EXHAUST HOSE
foam
seal The exhaust hose and adapter must be installed or removed in accordance with
the usage mode (install for COOL and remove for FAN or DRY).
slider
kit
1. Snap the adapters onto the ends of
the exhaust hose.
2. Push the unit adapter end into the air
outlet opening on the back of the unit.
3. Insert the other end of the exhaust hose into the hole in the window slider kit.
WARNING: DO NOT over extend, bend or twist
the exhaust hose!
Installation (cont.)
exhaust hose
unit adapter
1 888 557 3848
• • •
9