Asus PRIME X370-A Manual page 43

SATA Port Enable [Enabled]
Enables or disables the SATA ports. Configuration options: [Disabled] [Enabled]
SATA Mode [AHCI]
Allows you to set the SATA configuration.
[RAID] Set to [RAID] when you want to create a RAID configuration from the SATA
hard disk drives.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use the AHCI
(Advanced Host Controller Interface). The AHCI allows the onboard storage
driver to enable advanced Serial ATA features that increases storage
performance on random workloads by allowing the drive to internally
optimize the order of commands.
SMART Self Test [On]
SMART (Self‑Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power‑on Self Test) when an error occurs in the
hard disks. Configuration options: [On] [Off]
Hot Plug [Disabled] (SATA6G_1 (Gray) ~ SATA6G_6(Gray))
These items allow you to enable/disable SATA Hot Plug Support. Configuration options:
[Disabled] [Enabled]
2.6.4 Onboard Devices Configuration
HD Audio Controller [Enabled]
[Enabled] Enables the HD Audio Device.
[Disabled] Disables the HD Audio Device.
The following two items appear only when you set the HD Audio Controller item to
[Enabled].
Front Panel Type [HD Audio]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC'97 or
high‑definition audio depending on the audio standard that the front panel audio
module supports.
[HD]
[AC97]
SPDIF Out Type [SPDIF]
[SPDIF]
[HDMI]
LED Lighting [Breathing Mode]
Allows you to set the behavior of the audio LED. Configuration options: [Disabled] [Still Mode]
[Breathing Mode]
Fan RGB [Enabled]
Enables or disables the fan RGB. Configuration options: [Enabled] [Disabled]
Chapter 2: BIOS information
Sets the front panel audio connector (AAFP) mode to high definition
audio.
Sets the front panel audio connector (AAFP) mode to legacy AC'97.
Sets to an SPDIF audio output.
Sets to an HDMI audio output.
2-22