Download Print this page

Electrical Connection - Zanussi ZTB2000A-A Instruction Manual

Advertisement

– WARNING: When positioning the appliance, ensure the supply cord is not trapped or damaged.
– WARNING: Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.
Climate Range
The information about the climate range of the appliance is provided on the rated plate. It indicates at which ambient
temperature (that is, room temperature, in which the appliance is working) the operation of the appliance is optimal
(proper).
Note:The limit values of the range of ambient temperature for the climate classes for which the refrigerating appliance is
designed and the fact that the internal temperatures could be affected by such factors as the location of the refrigerating
appliance, ambient temperature and the frequency of door opening, and, if appropriate, a warning that the setting of any
temperature control device might have to be varied to allow for these factors;

Electrical Connection

Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it
replaced by an authorized service center.
This refrigerator should be properly grounded for your safety. The power cord of this refrigerator is equipped with a
three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.
Do not, under any circumstances, cut or remove the third ground prong from the power cord supplied.
This refrigerator requires a standard 220 -240V A.C. ~/50Hz electrical outlet with three-prong ground.
This refrigerator is not designed to be used with an inverter.
The cord should be secured behind the refrigerator and not left exposed or dangling to prevent accidental injury.
Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and pull straight out from the
receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service
technician install an outlet near the appliance. Use of an extension cord can negatively affect the performance of the
unit.
Prepare with requirements
Installation Location
When selecting a position for your Refrigerator you should make sure the floor is flat and firm, and the room is well
ventilated. Avoid locating your Refrigerator near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight in
out-buildings or sun lounges. If you are placing your Refrigerator in an out-building such as a garage or annex ensure that
the Refrigerator is placed above the damp course, otherwise condensation will occur on the Refrigerator cabinet. Never
place the Refrigerator in a wall recess or into fitted cabinets or furniture. When your Refrigerator is working, the grille at
the back may become hot and the sides warm. Therefore, the back part of the refrigerator must be installed at least 50mm
of free space, both sides should be left more than 100mm. Do not drape the Refrigerator with any covering.
Dimensions in mm
W
D
545
590
545
590
Note:Figure 1, Figure 2 only as a product space demand size schematic diagram.
Leveling the Refrigerator
If the Refrigerator is not level, the door and magnetic seal alignment will be affected and may cause you
Refrigerator to work incorrectly. Once the Refrigerator is placed in its final location, adjust the leveling
feet at the front by turning them.
Classified as Internal
Climate range
SN
N
ST
T
H
A
1465
845
1700
845
Fig. 1
Permissible ambient
temperature
from +10°C to +32°C
from +16°C to +32°C
from +16°C to +38°C
from +16°C to +43°C
WARNING
B
E
C(°)
1095
125
50
1095
125
50
Fig. 2
F
100
100

Advertisement

loading

This manual is also suitable for:

Ztb2500a-a