Precautions For Cordless Driver Drill; Specifications - Hitachi FDS 10DVA Handling Instructions Manual

24 . Never use a battery other than that specified. Do
not connect a usual dry cell, a rechargeable battery
other than that specified or a car battery to the
power tool.
25. Do not use any transformer containing a booster.
26. Do not charge the battery from an engine electric
generator or DC power supply.
27. Always charge indoors. As the charger and battery
heat-up slightly during charging, charge the battery
in a place not exposed to direct sunlight, whch
has low humidity and is well ventilated.
28. When working in a high place, pay attention to
activities below. Before commencing, ensure that
there are no people below.

PRECAUTIONS FOR CORDLESS DRIVER DRILL

1. Always charge the battery at a temperature of 10 –
40°C. A temperature of less than 10°C will result
in over charging which is dangerous. The battery
cannot be charged at a temperature higher than
40°C. The most suitable temperature for charging
is that of 20 – 25°C.
2. Do not use the charger continuously.
When one charging is completed, leave the charger
for about 15 minutes before the next charging of
battery.

SPECIFICATIONS

POWER TOOL
Model
No-load speed (Low/High)
Wood
Drilling
Metal
Capacity
Machine screw
Driving
Wood screw
Rechargeable battery (FEB9)
Weight
CHARGER
Model
Charging time
Charging voltage
Weight
3.
4.
5.
6.
7.
8.
9.
10.
11.
Steel: 10 mm, Aluminum: 10 mm
5.5 mm (diameter) × 45 mm (length) (There is a pilot hole)
UC9SC
Approx. 1 hour (at 20°C)
9.6 V
1.2 kg
Do not allow foreign matter to enter the hole for
connecting the rechargeable battery.
Never disassemble the rechargeable battery and
charger.
Never short-circuit the rechargeable battery. Short-
circuiting the battery will cause a great electric
current and overheat. It results in burn or damage
to the battery.
Do not dispose of the battery in fire.
If the battery is burnt, it may explode.
When drilling in wall, floor or ceiling, check for
buried electric power cord, etc.
Bring the battery to the shop from which it was
purchased as soon as the post-charging battery
life becomes too short for practical use. Do not
dispose of the exhausted battery.
Using an exhausted battery will damage the
charger.
Do not insert object into the air ventilation slots
of the charger.
Inserting metal objects or inflammables into the
charger air ventilation slots will result in electrical
shock hazard or damaged charger.
When mounting a bit into the keyless chuck, tighten
the sleeve adequately. If the sleeve is not tight,
the bit may slip or fall out, causing injury.
FDS10DVA
0 – 280/0 – 850/min.
18 mm
6 mm
Ni-Cd battery, 9.6 V
1.5 kg
English
23