Electrolux LUT6NE18C User Manual page 16

16 www.electrolux.com
Problem
The temperature in the ap‐
pliance is too low/too high.
DEMO appears on the dis‐
play.
A or
shown instead of numbers
on the temperature dis‐
play.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Closing the door
1. Clean the door gaskets.
Possible cause
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The FastFreeze function is
switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in demon‐
stration mode.
Temperature sensor prob‐
or symbol is
lem.
Solution
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion" section.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and Tips" chapter.
Keep the OK key pressed
for approximately 10 sec‐
onds until a long sound is
heard and the display turns
off for a short time.
Contact the nearest Au‐
thorized Service Centre
(the cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible).
2. If necessary, adjust the door. Refer
to installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.