Advertisement
INSTALLATION
SELECTING A SUITABLE LOCATION
When selecting a position for your unit, ensure the floor is flat and firm, and
the room is well ventilated. Avoid placing your unit near a heat source (ie,
oven, radiator, or hot water system). Avoid direct sunlight as it may increase
the electrical consumption. Extreme cold temperatures may also cause the
unit to not perform correctly. This unit is not designed for use in a garage or
outdoors. Do not drape the unit with any covering.
When installing the unit, ensure that 15cm of free space is allowed to the
left, right and rear of the unit, and 20cm at the top. This will allow cold air to
circulate around the unit and improve the efficiency of the cooling process.
1a. Door space requirements
The unit's door must be able to open fully
as pictured (1a).
1b. Levelling the unit
To level the unit, adjust the two feet at
the front of the unit – turning clockwise
to extend and counter-clockwise to
reduce (1b). If the unit is not level, the
door and magnetic seal alignments
will not be covered properly, leading to
inefficient freezing performance. Ensure
that the feet all touch the ground before
use.
6
Figure 1a
Figure 1b
Advertisement
