Table of Contents
Advertisement
INSTALLATION
•
2-person installation: Use two or more people to move and install the appliance.
Failure to do so can result in back or other injury
•
Freestanding design: This appliance is designed to be freestanding only and
should not be recessed or built-in.
•
Floor surface: This appliance must be properly positioned on a dry, sturdy, level
surface that is strong enough to support it when it is fully loaded.
•
Ambient temperature: The ambient temperatures must correspond to the climate
class (ST/N) indicated on the rating plate of the appliance: 16°C - 38°C
•
Clearances: Ensure that air can circulate freely around the back of the cabinet,
which is necessary to cool the compressor and condenser. Allow at least 10cm
clear space at the back, 10cm at the sides of the unit and 30cm between the top
and any surface above (i.e. a bench top). If you are installing your refrigerator next
to a fixed wall, leave enough space on the hinge side to allow for the door to swing
open.
•
Do NOT install/use the appliance in the following locations/situations:
o
In a recreational vehicle or for use with an inverter
o
In direct sunlight, near heat sources, next to an open flame, cooking, or
heating appliance or near any other source of high heat.
o
Direct sunlight may affect the acrylic coating and heat sources may
increase the unit's power consumption. For best energy efficiency install
the appliance in the coolest area of the room.
o
In an area with extremely cold ambient temperatures.
o
In an area with excessive moisture and high humidity. Make sure it is
protected from elements such as wind, rain, water spray or drips.
o
In an area where petrol or other explosive and/or flammable liquids or
fumes are used or stored. The fumes can create a fire hazard or explosion.
Advertisement
Table of Contents
