WAREMA 1002 219 Operating And Installation Instructions

Operating and installation instructions
WAREMA Timer
Keep for future use!
Valid from 1st December 2011
General
Fig. 1 WAREMA Timer
The WAREMA Timer is a time switch with floating output
specifically for actuating roller shutters. These can be
controlled automatically using an integrated time switch
control and a dawn/dusk control. The dawn/dusk control
using astronomical data (date and location) to calculate
the time of dusk.
Intended use
The device was developed to control sun shading sys-
tems. The approval of the manufacturer must be obtained
for uses outside of the purposes listed in these instruc-
tions.
Safety information
WARNING
The electrical installation must be per-
formed by a certified electrician in accord-
ance with the electrical installation regu-
lations published by the Association of
German Electrical Engineers (VDE 0100)
or the standards and regulations of the
country in which the device is being in-
stalled. The specialist must observe the
installation instructions included with
the electrical device.
WARNING
If hazard-free operation cannot be as-
sumed, the device may not be started or
must be deactivated. This assumption is
justified
 i f the housing or the supply lines show
signs of damage,
 the device is no longer working
WARNING
It is important to comply with the follow-
ing points of instruction in the interest of
personal safety!
890214_b•en•07.11.2011
All manuals and user guides at all-guides.com
■
■
■
■
Function
The buttons
directly and the
rection is used to pause the movement. The button
be used to switch the time switch control on and off. When
the time switch control is active, the
on the display. You can set an upward movement and a
downward movement for each day. With the automated
random function activated, the switch times programmed
via the time switch control are changed randomly by + / -
30 min (a dice is displayed on the display). This creates
the impression that the roller shutter is being moved up
and down manually. The
the dawn/dusk control on and off. When the dawn/dusk
control is active, the
The dawn/dusk times calculated can still be changed by
+ / - 60 min. With the dawn/dusk control switched on, a
down movement command is initiated in the evening at
the time calculated. In the morning, the sun protection can
either be raised via the time switch control or manually.
The
movement when activated.
Installation
The device is mounted in a deep flush-fitted wall box. This
makes connecting the terminals easier.
■
■
As an option, the device can also be mounted in a
surface-mounted box.
Fig. 2
Children may not play with the operating elements of the
control unit!
Make sure that no persons or objects are in the range of
movement of the driven parts (blinds, window, etc.!
Disconnect the product from the supply voltage if clean-
ing or other maintenance work must be performed!
The device may only be used to control drives where the
movement of the product (roller shutter) cannot cause
any injury.
and can be used to control your blind
button or the button for the opposite di-
button can be used to switch
character appears on the display.
button display the last cause and the direction of
Mount the device only in inside areas! The device is
not suitable for use in damp interiors.
The electrical connection of the product is done ac-
cording to the wiring diagram given below.
Connecting and disconnecting the line connections
We reserve the right to carry out improvements
can
character appears
1