Toro Z Master Professional 5000 Series Setup Instructions page 7

4. Plug the harness connector into the seat switch
located under the seat towards the front.
5. Install the seat to the machine frame with 4
flange nuts (3/8 inch).
1. Harness connector
Installing the Seat on Models with
a Tilting Seat
1. Tilt the seat frame up.
2. For deluxe seats only, install the spacers as
shown in Figure
Figure 12
Figure 13
2. Flange nuts
14.
g010184
For machines with a deluxe seat only
1. Deluxe seat
2. Long spacer
3. Install the seat to the seat frame with 4 flange
nuts (3/8 inch) as shown in
4. Plug the harness connector into the seat switch
located under the seat toward the front.
g010185
1. Seat switch
2. Flange nuts
7
Figure 14
3. Seat frame
4. Short spacers
Figure 15.
Figure 15
3. Harness connector
g030558
g010192