Display Settings - ProAudio PP107234 Instruction Manual

Audio Settings
[SW LPF SLOPE] [–6DB]/[–12DB]/[–18DB]/[–24DB]: Adjusts the
[SW LPF
PHASE]
[SW LPF GAIN]
[DTA SETTINGS]
For settings, see the following "Digital Time Alignment settings".
[CAR SETTINGS]
• The following item is selectable only if [SWITCH PREOUT] is set to [SUB-W]
(page 5):
– [SUB-W LEVEL]
– [SUBWOOFER SET]
– [SW LEVEL] of [EASY EQ]
– [SUBWOOFER] of [SPEAKER SIZE]
– [SUBWOOFER LPF] of [X ' OVER]
– [SUBWOOFER] of [DISTANCE] and [GAIN] in [DTA SETTINGS]
• The following item is selectable only if [SUBWOOFER SET] is set to [ON]
(page 18):
– [SUB-W LEVEL]
– [SW LEVEL] of [EASY EQ]
– [SUBWOOFER] of [SPEAKER SIZE]
– [SUBWOOFER LPF] of [X ' OVER]
– [SUBWOOFER] of [DISTANCE] and [GAIN] in [DTA SETTINGS]
• The following item is selectable only if a setting other than [NONE] is
selected for [TWEETER], [REAR] and [SUBWOOFER] of [SPEAKER SIZE]:
– [TWEETER], [REAR HPF], [SUBWOOFER LPF] of [X ' OVER]
20 ENGLISH
crossover slope.
(Selectable only if a setting other than [THROUGH] is
selected for [SW LPF FRQ].)
[REVERSE] (180°)/[NORMAL] (0°): Selects the
phase of the subwoofer output to be in line with the
speaker output for optimum performance.
[–8] to [0]: Adjusts the output volume of the
subwoofer.

Display Settings

Zone identification for brightness setting
Set the dimmer
Press and hold DISP (DIM) to turn on or off the dimmer.
• Once you press and hold this button, [DIMMER] setting (page 21) will be
overwritten.
Change the display settings
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (page 21), then press the
knob.
3
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press and hold to exit.
To return to the previous setting item, press .