Renkforce IP65 Operating Instructions Manual page 27

9.2.1 Deleting the user password
Enter the following key combination in programming mode to delete a user password:
50 XX
XX in this case stands for the user (01 to 99) to be deleted. If all users are to be deleted, enter
"00" instead of a number between 01 and 99.
9.3 Setting operating mode
The code lock can be operated in one of two operating modes "Normal-Mode" or "Bypass-
Mode".
In "Normal-Mode" you enter the user password to activate an attached door opener.
In "Bypass-Mode", once the "Bypass-Code" is entered, the door opener remains activated with-
out an alarm being triggered. Enter the following key combination while in programming mode:
52 0
Normal-Mode
52 1
Bypass-Mode
9.3.1 Setting Bypass Code
Enter the following key combination in programming mode to set the bypass code:
54 BBBB
BBBB in this case stands for the Bypass Code.
9.3.2 Using Bypass Mode
The bypass mode can only be used when the bypass mode has been specified in
programming mode (combination
signed.
Enter the bypass code while in programming mode. This activates the "Lock Out" relay contacts (1).
The "green" LED (B) is lit as visual confirmation of the setting.
To deactivate the "Lock Out" relay contacts (1) enter the bypass code again. The "green"
LED (B) is no longer lit.
521) and a bypass code has also been as-
27