Mitsubishi Electric QX10-TS User Manual page 124

9 SPRING CLAMP TERMINAL BLOCK
9.2 Spring Clamp Terminal Block (Q6TE-18S, Q6TE-18SN)
9 - 6
The Q6TE-18S and Q6TE-18SN (hereafter abbreviated as Q6TE-18S(N)) shall be
used attached to a Q Series terminal block type I/O module or an intelligent function
module.
Since the Q6TE-18S(N) uses a spring clamp it does not require screw tightening,
which greatly reduces the number of wiring procedures.
(1)
Applicable modules
For the modules that can be used with the Q6TE-18S and Q6TE-18SN, refer to
the user's manuals included with the terminal blocks.
(2) Specifications
The Q6TE-18S(N) specification is explained.
Item
Applicable wire size
Maximum rated voltage, maximum rated
current
Wire strip length
Mounting screw tightening torque range
Weight
(3) Removing a terminal block
Unscrew the two terminal block mounting screws situated at the top and bottom
of the terminal block and take them off.
Specifications
0.3 to 1.5 mm (22 to 16 AWG)
2
264VAC
125VDC
8A (terminal number: 17)
4A (terminal number: 1 to 16, 18)
8 to 11 mm
0.66 to 0.89 Nm
0.07kg
Module
Terminal
block mounting
screw
Terminal block
MELSEC-Q
9 - 6