Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Advanced Wireless Communications HD-1000V2
Summary of Contents for Advanced Wireless Communications HD-1000V2
- Page 1 HD-1000V2...
-
Page 2: Ordering Replacement Parts
GENERAL/概述 INTRODUCTION 引言 SCOPE OF THIS MANUAL 本手册的范围 本手册是提供给熟悉通信专业并且具有维修经验的技术人员 This manual is intended for use by experienced technicians 使用的。 它包括了维修该设备所 需要的全部资料和现行公布 familiar with similar types of commercial grade communications 的数据。在出版 后可能发生变动，如果需要，可以使用《维修 equipment. It contains all required service information for the 通报》或《手册修订本》进行补充。... -
Page 3: Safety Training Information
SAFETYTRAINING INFORMATION Your radio generates RF electromagnetic energy during transmit mode. This radio is designed for and classified as “Occupational Use Only”, meaning it must be used only during the course of employment by individuals aware of the hazards, and the ways to minimize such hazards. This radio is NOT intended for use by the “General Population”... -
Page 4: Explicit Definitions
ALWAYS keep the antenna at least 2.5 cm (1 inch) away from the body when transmitting and only use the belt-clip which is listed in instructions when attaching the radio to your belt, etc., to ensure FCC RF exposure compliance requirements are not exceeded. -
Page 5: Operating Notes
OPERATING NOTES When transmitting with a portable radio, hold the radio in a vertical position with its microphone 5 to 10 cm (2 to 4 inches) away from your mouth. Keep the antenna at least 2.5 cm (1 inch) from your head and body. If you wear a portable two-way radio on your body, ensure that the antenna is at least 2.5 centimeters (1 inch) from your body when transmitting. - Page 8 MODES 模式 PC模式 USER MODE PC MODE 用户模式 MODES FUNCTION 类型 模式 功能 User mode For normal use. 用户模式 用于普通操作 Used for communication between the radio Used for communication between the radio PC mode 计算机模式 and a PC and a PC How to enter each mode PROCEDURE MODES...
- Page 9 DISASSEMBLY FOR REPAIR/维修时拆卸部分 Separating the case assembly from the chassis 从底座上分离外壳 Remove the knob 1 and the round nut 2 1.取下旋扭 和环形螺母 2.取下六颗螺钉 和 Remove the six screws 3 and 4 3.掀开外壳底部的左右两侧，取下底座，并外壳中取出 Expand the right and left sides of the bottom of the case assembly, lift the chassis, and remove it from the case assembly 5.
- Page 10 FCC ID: Q9SHD-1000V2 IC: 4651A-HD1000V2 NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.