Installation - Electrolux EUF1840AOW User Manual

10 www.electrolux.com

10. INSTALLATION

Read the Safety information carefully for
your safety and correct operation of the
appliance before installation.
10.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Climate class
SN
N
ST
T
10.2 Location
The appliance should be installed well
away from sources of heat such as
radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely
around the back of the cabinet.
To ensure best performance, if the
appliance is positioned below an
overhanging wall unit, the minimum
distance between the top of the
cabinet and the wall unit must be as
least 100 mm. Ideally, however, the
appliance should not be positioned below
overhanging wall units. Accurate levelling
is ensured by one or more adjustable
feet at the base of the cabinet.
WARNING! It must be possible to
disconnect the appliance from the
mains power supply; the plug must
therefore be easily accessible
after installation.
10.3 Electrical Connection
Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your domestic
power supply. The appliance must be
earthed.
Ambient
temperature
+10ºC to +32ºC
+16ºC to +32ºC
+16ºC to +38ºC
+16ºC to +43ºC
The power supply cable plug is provided
with a contact for this purpose. If
the domestic power supply socket is
not earthed, connect the appliance
to a separate earth in compliance
with current regulations, consulting
a qualified electrician.
The manufacturer declines all
responsibility if the above safety
precautions are not observed. This
appliance complies with the E.E.C.
Directives.
10.4 Levelling
The appliance should be level in order
to eliminate vibration. To make the
appliance level, it should be upright and
both adjusters should be firmly in contact
with the floor. You can also adjust the
level by screwing out the appropriate
level adjuster at the front (use your
fingers or a suitable spanner).
10.5 Installation
IMPORTANT! In order to reserve
the required space around the
appliance for ventilation, please
keep 100 mm distance between
two sides and top of the freezer
appliance and the wall and 50
mm distance between rear of
appliance and the wall.