Broan QTXE150FLT Quick Start Manual

Broan QTXE150FLT Quick Start Manual

Ventilation fan / light
Hide thumbs Also See for QTXE150FLT:
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

READ AND SAVE
THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the address
or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a promi-
nent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction codes and standards.
4. Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent backdrafting. Follow the heating equipment manufac-
turer's guideline and safety standards such as those published
by the National Fire Protection Association (NFPA), and the
American Society for Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code authorities.
5. When cutting or drilling into wall or ceiling, do not damage elec-
trical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Acceptable for use over a tub or shower when connected to a
GFCI (Ground Fault Circuit Interrupter) - protected branch circuit
(ceiling installation only).
8. This unit must be grounded.
CAUTION
1. For general ventilating use only. Do not use to exhaust hazardous
or explosive materials and vapors.
2. This product is designed for installation in ceilings up to a 12/12
pitch (45 degree angle). Duct connector must point up. DO NOT
MOUNT THIS PRODUCT IN A WALL.
3. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power unit.
4. Please read specification label on product for further information
and requirements.
CLEANING & MAINTENANCE
For quiet and efficient operation, long life, and attractive appear-
ance - lower or remove grille and vacuum interior of unit with the
dusting brush attachment.
The motor is permanently lubricated and never needs oiling. If the
motor bearings are making excessive or unusual noises, replace
the blower assembly (includes motor and impeller).
OPERATION
Use an on/off switch or speed control to operate this ventilator. See
"Connect Wiring" for details. Use of speed controls other than the
Broan Models 78V and 78W may cause a motor humming noise.
VENTILATION FAN / LIGHT
Register your
product online at:
www.broan.com/register
WARRANTY
Warranty Period and Exclusions: Broan-NuTone LLC (the "Company") warrants to the original
consumer purchaser of its product ("you") that the product (the "Product") will be free from
material defects in the Product or its workmanship for a period of three (3) years from the date of
original purchase.
The limited warranty period for any replacement parts provided by the Company and for any Products
repaired or replaced under this limited warranty shall be the remainder of the original warranty period.
This warranty does not cover speed controls, fluorescent lamp starters, tubes, halogen and in-
candescent bulbs, fuses, filters, ducts, roof caps, wall caps and other accessories for ducting that
may be purchased separately and installed with the Product. This warranty also does not cover
(a) normal maintenance and service, (b) normal wear and tear, (c) any Products or parts which
have been subject to misuse, abuse, abnormal usage, negligence, accident, improper or insufficient
maintenance, storage or repair (other than repair by the Company), (d) damage caused by faulty
installation, or installation or use contrary to recommendations or instructions, (e) any Product
that has been moved from its original point of installation, (f) damage caused by environmental or
natural elements, (g) damage in transit, (h) natural wear of finish, (i) Products in commercial or
nonresidential use, or (j) damage caused by fire, flood or other act of God. This warranty covers
only Products sold to original consumers in the United States by the Company or U.S. distributors
authorized by the Company.
This warranty supersedes all prior warranties and is not transferable from the original consumer
purchaser.
No Other Warranties: This Limited Warranty contains the Company's sole obligation and your sole
remedy for defective products. The foregoing warranties are exclusive and in lieu of any other war-
ranties, express or implied. THE COMPANY DISCLAIMS AND EXCLUDES ALL OTHER EXPRESS
WARRANTIES, AND DISCLAIMS AND EXCLUDES ALL WARRANTIES IMPLIED BY LAW, INCLUDING
WITHOUT LIMITATION THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PUR-
POSE. To the extent that applicable law prohibits the exclusion of implied warranties, the duration
of any applicable implied warranty is limited to the period specified for the express warranty above.
Some states do not allow limitations on how long an implied warranty lasts, so the above limita-
tion may not apply to you. Any oral or written description of the Product is for the sole purpose of
identifying it and shall not be construed as an express warranty.
Whenever possible, each provision of this Limited Warranty shall be interpreted in such manner as
to be effective and valid under applicable law, but if any provision is held to be prohibited or invalid,
such provision shall be ineffective only to the extent of such prohibition or invalidity, without invali-
dating the remainder of such provision or the other remaining provisions of the Limited Warranty.
Remedy: During the applicable limited warranty period, the Company will, at its option, provide
replacement parts for, or repair or replace, without charge, any Product or part thereof, to the extent
the Company finds it to be covered by and in breach of this limited warranty under normal use and
service. The Company will ship the repaired or replaced Product or replacement parts to you at no
charge. You are responsible for all costs for removal, reinstallation and shipping, insurance or other
freight charges incurred in the shipment of the Product or part to the Company. If you must send the
Product or part to the Company, as instructed by the Company, you must properly pack the Product
or part—the Company is not responsible for damage in transit. The Company reserves the right to
utilize reconditioned, refurbished, repaired or remanufactured Products or parts in the warranty repair
or replacement process. Such Products and parts will be comparable in function and performance
to an original Product or part and warranted for the remainder of the original warranty period.
Exclusion of Damages: THE COMPANY'S OBLIGATION TO PROVIDE REPLACEMENT PARTS, OR
REPAIR OR REPLACE, AT THE COMPANY'S OPTION, SHALL BE YOUR SOLE AND EXCLUSIVE
REMEDY UNDER THIS LIMITED WARRANTY AND THE COMPANY'S SOLE AND EXCLUSIVE OBLI-
GATION. THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL, INDIRECT, CONSEQUENTIAL
OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH THE PRODUCT, ITS USE
OR PERFORMANCE.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you. This warranty gives you specific legal rights,
and you may also have other rights, which vary from state to state.
This warranty covers only replacement or repair of defective Products or parts thereof at the
Company's main facility and does not include the cost of field service travel and living expenses.
Any assistance the Company provides to or procures for you outside the terms, limitations or exclu-
sions of this limited warranty will not constitute a waiver of such terms, limitations or exclusions,
nor will such assistance extend or revive the warranty.
The Company will not reimburse you for any expenses incurred by you in repairing or replacing
any defective Product, except for those incurred with the Company's prior written permission.
How to Obtain Warranty Service: To qualify for warranty service, you must (a) notify the Company
at the address or telephone number stated below within seven (7) days of discovering the covered
defect, (b) give the model number and part identification and (c) describe the nature of any defect
in the Product or part. At the time of requesting warranty service, you must present evidence of
the original purchase date. If you cannot provide a copy of the original written limited warranty,
then the terms of the Company's most current written limited warranty for your particular product
will control. The most current limited written warranties for the Company's products can be found
at
www.broan.com
Broan-NuTone LLC 926 West State Street, Hartford, WI 53027
www.broan.com
800-637-1453
Installer: Leave this manual with
MODEL QTXE150FLT
Limited Warranty
.
the homeowner.
Page 1

Advertisement

Table of Contents
loading

Summary of Contents for Broan QTXE150FLT

  • Page 1 Limited Warranty INJURY TO PERSONS, OBSERVE THE FOLLOWING: Warranty Period and Exclusions: Broan-NuTone LLC (the “Company”) warrants to the original 1. Use this unit only in the manner intended by the manufacturer. consumer purchaser of its product (“you”) that the product (the “Product”) will be free from...
  • Page 2: Typical Installations

    VENTILATION FAN / LIGHT MODEL QTXE150FLT Page 2 TYPICAL INSTALLATIONS Housing mounted anywhere between trusses using Housing hanger bars. mounted to I-joists. Use I-joist spacer block (provided). PLAN THE INSTALLATION Housing mounted COOKING AREA anywhere Do not install above or between inside this area.
  • Page 3: Installation

    VENTILATION FAN / LIGHT MODEL QTXE150FLT Page 3 INSTALLATION 1a. Mount To ensure a noise-free mount: Secure hang- housing to ing bars together with joist. SCREWS and use a SPACER pliers to crimp mount- Hold housing (use for ing channels tightly...
  • Page 4: Service Parts

    VENTILATION FAN / LIGHT MODEL QTXE150FLT Page 4 7. Push grille against 8. Remove light lens. ceiling. Carefully insert a small flat-blade screwdriver between grille and lens. Pry lens out. 9. Install light bulbs. 3.9" (100mm) M.O.L. Product includes (2) 18W (max.),...
  • Page 5: Limpieza Y Mantenimiento

    Garantía limitada LESIONES PERSONALES, OBSERVE LAS SIGUIENTES PRECAUCIONES: Periodo y exclusiones de la garantía: Broan-NuTone LLC (la “Compañía”) garantiza al consumidor 1. Use la unidad sólo de la manera indicada por el fabricante. Si tiene preguntas, comprador original de su producto (“usted”) que el producto (el “Producto”) estará libre de defectos en comuníquese con el fabricante a la dirección o al número telefónico que se...
  • Page 6: Instalaciones Típicas

    VENTILADOR / LUZ MODELO QTXE150FLT Página 6 INSTALACIONES TÍPICAS Montaje de la cubierta en Montaje de la cualquier parte cubierta en entre armaduras viguetas “I” . por medio de barras de Utilice un taco suspensión. separador de viguetas “I” (suministrado).
  • Page 7 VENTILADOR / LUZ MODELO QTXE150FLT Página 7 INSTALE LA CUBIERTA Para lograr un montaje Y EL CONDUCTO silencioso: acople y fije las barras de suspensión con TORNILLOS, y doble 1a. Monte la los canales de montaje ESPACIADOR cubierta en con un alicate bien...
  • Page 8: Piezas De Repuesto

    VENTILADOR / LUZ MODELO QTXE150FLT Página 8 8. Saque la lente de la lámpara. 7. Empuje la rejilla contra el cielo raso. Con cuidado, inserte un destornillador plano pequeño entre la parilla y la lente de lámpara. Haga palanca con el destornilla- dor y saque la lente.

Table of Contents