Adjusting Oven Temperature; Oven Cleaning - Frigidaire FEFD67CHSE User Manual

Adjusting Oven Temperature

Note : The adjustments made will not change the self-cleaning temperature.
When first using the oven, be sure to follow recipe times and temperatures. If you think the oven is too hot or too cool, the
temperature in the oven can be adjusted. Before adjusting, test a recipe by using a temperature setting that is higher or lower
temperature than the recommended temperature. The baking results should help you to decide how much of an adjustment
is needed.
To Adjust Oven Temperature:
1. Push BAKE .
2. Set the temperature to 500°F (260°C) by pushing the UP ARROW
3. Within 15 seconds, push and hold BAKE
indicates the amount of degrees offset between the original factory temperature setting and the current temperature
setting. If the oven control has the original factory calibration, the display will read "00."
4. The temperature can now be adjusted up or down 35°F (17°C), in 5°F (1°C) steps, by pushing and holding the UP
DOWN ARROW. Adjust until the desired amount of offset appears in the display, a minus sign (-) will appear before
the number to indicate that the oven will be cooler by the displayed amount of degrees.

Oven Cleaning

To Start the Self-Clean Cycle
*We recommend a 2 hour self-clean cycle for light soils and a 3 hour cycle for average to heavy soils.
To Set the Controls for a Self-Clean Cycle:
1. Be sure the clock shows the correct time of day, and the door is closed.
2. Push CLEAN . "— — —" appears in the display.
3. Push the UP ARROW
appears in the display for a 2 hour cycle.
4. As soon as the UP or DOWN
light will flash "CLN" appears in the display. After approximately 10 seconds. "DR" and "CLN" will show in the display
three beeps sound when the cleaning cycle begins. DO NOT open the door while the light is flashing (it takes about 15
seconds for the lock to close). When the light stops flashing the door is locked.
Stopping or Interrupting a Self-Cleaning Cycle
If it becomes necessary to stop or interrupt a self-cleaning cycle:
1. Push CANCEL .
2. Once the oven has cooled down and the "LOCKED" light has gone out, the oven door can be opened.
When the Self-Clean Cycle is Completed:
1. The time of day will appear in the display window and the "LOCKED" light will continue to glow.
2. Once the oven has cooled down and the "LOCKED" light has gone out, the oven door can be opened.
DO NOT force the oven door open. This can damage the automatic door locking system. Use caution when
opening the door after the self-cleaning cycle is completed. The oven may still be VERY HOT.
until the special 2 digit display appears. Release BAKE
until "3:00" appears in the display for a 3 hour cycle, or push the DOWN ARROW
ARROW is released, the motor driven lock will begin to close and the "Locked" indicator
ELECTRONIC OVEN CONTROL
.
4
. The display now
or
until "2:00"