6.
Assemble the right control-arm panel to the
control arm
(Figure
screw (#10 x 3-1/2 inches), locknut (#10), and 5
flange-head screws (#10 x 3/8 inch).
1. Locknut (#10)
2. Phillips-head screw (#10 x
3-1/2 inches)
5
Assembling the Front Light
Bar Assembly
Parts needed for this procedure:
1
Front light bar assembly
1
Right light assembly
1
Left light assembly
2
Hex-head bolt (12 x 80 mm)
Procedure
1.
Remove the fasteners from the right light
assembly.
Retain the locknut (12 mm) and lock washer (12
mm). Discard the screw.
2.
Secure the right light assembly to the front light
bar assembly using 1 new hex-head bolt (12
x 80 mm) and the previously removed locknut
(12 mm) and lock washer (12 mm) as shown in
Figure
22.
21) with the Phillips-head
Figure 21
3. Flange-head screw (#10 x
3/8 inch)
4. Right control-arm panel
Important:
as you could damage the light assembly.
g351204
1. New hex-head bolt (12 x
80 mm)
2. Right light assembly
3. Front light bar assembly
3.
Repeat steps
9
Do not overtighten the fasteners,
Figure 22
4. Previously removed lock
washer (12 mm)
5. Previously removed
locknut (12 mm)
1
and
2
on the left side.
g344461