Table of Contents
Advertisement
en Cleaning and servicing
Make sure that the impeller in the
3.
drain pump can be turned.
Replace the pump cap.
4.
Make sure that the components of
the pump cap are securely seated.
Screw on the pump cap.
5.
90°
The handle on the pump cap must
be in a vertical position.
Insert the maintenance flap and lock
6.
it into place.
52
1
Close the maintenance flap.
7.
Before the next wash
To prevent unused detergent from flow-
ing straight into the outlet in the next
wash, run the
Drain programme
after you have emptied the drain pump.
Turn on the tap.
1.
Insert the mains plug.
2.
Switch on the appliance.
3.
Pour approx. 1 litre of water into the
4.
manual dosing compartment.
Start the
Drain programme.
5.
Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon is
dirty or the detergent solution is not be-
ing pumped out, you must clean these.
Switch off the appliance.
1.
Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and carefully
3.
remove the water outlet hose.
2
Advertisement
Table of Contents
