Mounting The Unit On A Wall - Yamaha YSP-1600B Owner's Manual

1 2 3 4 5 6

Mounting the unit on a wall

The unit can be mounted on a wall.
If the antenna will be used (p. 13), raise it before
mounting the unit on a wall.
• When installing the unit on a wall, all installation work must be
performed by a qualified contractor or dealer. The customer must
never attempt to perform this installation work. Improper or
inadequate installation could cause the unit to fall, resulting in
personal injury.
• To prevent the unit from falling, attach it to a wall constructed of
drywall (plasterboard).
• Make sure you use commercially available screws that can support
the weight of the installation (in step 2). Using clamps other than
specified screws, such as short screws, nails, and two-sided tape,
may cause the unit to fall.
• Fix the cables in place where they will not become loose. If your foot
or hand accidentally gets caught on a loose cable, the unit may fall.
• Check that the unit is fixed securely after the installation. Yamaha
will bear no responsibility for any accidents caused by improper
installations.
• Do not lean on the unit or apply excessive force to the top of the
unit. Doing so may cause the unit to fall.
1
Attach the mounting template on a wall
and mark for the screw holes.
thumbtacks
Mounting template (supplied)
ANTENNA / ANTENNE
MOUNTING TEMPLATE/GABARIT DE FIXATION DRILL HERE / PERCER CIC
457mm (18" )
457mm (18 po)
Screw
holes
2
Remove the mounting template from the
wall and install the commercially available
screws at the marks on the wall.
ANTENNA / ANTENNE
DRILL HERE / PERCER CIC
MOUNTING TEMPLATE/GABARIT DE FIXATION
457mm (18" )
457mm (18 po)
7 to 9 mm
(1/4" to 3/8")
20 mm (3/4") or more
2 to 4 mm
(1/16" to 3/16")
3
Use the screws to attach the brackets
(both supplied).
Tapes or
Position the
bracket so that
the protrusions
on the side of the
DRILL HERE / PERCER CIC
bracket fit into
ZR85910-1
the grooves on
the unit.
4
Hang the unit on the screws.
DRILL HERE / PERCER CIC
ZR85910-1
MOUNTING TEMPLATE/GABARIT DE FIXATION
4 mm (#8)
PREPARATIONS ➤ a Installation
Screws
Brackets
(supplied)
(supplied)
ANTENNA / ANTENNE
DRILL HERE / PERCER CIC DRILL HERE / PERCER CIC
457mm (18" )
457mm (18 po)
ZR85910-1
Bracket
mounting
holes
En
14