Panasonic CQ-VD7005W2 Operating Instructions Manual page 62

Electrical Connections
Caution
¡This unit is designed for use in a car having a 12 V negative ground battery system.
¡Be sure to insulate any exposed wires from the car chassis. Bundle all cables and keep cable terminals free from
any metal parts.
9
¡Note that if your car has a driving computer or a navigation computer, disconnecting the cable from the battery
may clear the memory.
¡Run the cords avoiding the spots where the temperature can be extremely high.
Navi Mute Lead (Orange)
Connect to the Navi Mute Lead of the Panasonic car
navigation system. (available in future)
ANT-CONT MAX 0.1A
Motor Antenna Relay Control Lead (Blue)
(To motor antenna) (Max. 100 mA)
This lead is not intended for use with a switch actuated
power antenna.
SIDE BRAKE
Side Brake (Parking Brake) Connection Lead (Bright
green)
Be sure to wire the side brake (parking brake) for safety and
preventing accidents.
AMP-CONT MAX 0.1A
External Amplifier Control Power Lead (Blue/white stripe)
To an external amplifier.
Note:
¡Use the power control lead of the TV tuner for TV
tuner connection.
¡Connect both the power control lead of the TV
tuner and the amplifier control connector of the
external amplifier when the TV tuner and external
amplifier are connected at the same time.
Power Lead (Red)
To ACC power, +12 V DC.
Battery Lead (Yellow)
To the car battery, continuous +12 V DC.
BATTERY 15 A
(Fuse 15 A)
Ground Lead (Black)
To a clean, bare metallic part of the car chassis
10
CQ-VD7005W
NAVI MUTE
(a page 9)
ACC
Ω
(Resistor 1 k )
(Noise Filter)
!3
Power Connector
Front Right + (Gray)
Front Right – (Gray/black stripe)
FRONT SP
Front Left + (White)
Front Left – (White/black stripe)
Rear Right + (Violet)
Rear Right – (Violet/black stripe)
REAR SP
Rear Left + (Green)
Rear Left – (Green/black stripe)
Speaker connections
• Do not connect more than one speaker to one set of
speaker leads (except for connecting to a tweeter).
Use of speakers which do not match the specifications
can cause burning, smoking or damage of the speakers.
• Do not use a 3-wire type speaker system having a com-
mon earth lead.