Configuration Screen; Battery Charging; Package - Satlink ST-5810 Operation Manual

2.3.3 CONFIGURATION SCREEN

Parameter description

2.4 BATTERY CHARGING

The ST-5810 has built-in 7.4V/2000mAh Li-Ion battery installed. When fully charged, it can be used for up to 8 hours. When the
battery capacity drops below 10%, the battery symbol shows red at the top of the display screen. If the charge drops below
6.4V, the ST-5810 shuts off automatically to protect the battery. The ST-5810 cannot be turned on again until it's recharged.
To charge the ST-5810 battery, connect the battery charger to the charge socket on the bottom of ST-5810 (see chapter 2,
section 2.: Identify Components) and plug the charger into an AC outlet. The battery must be charged with the SatLink
charge cube provided with the ST-5810. Using other charge cube may damage the battery.
A full charge will be achieved in less than three hours. The charging status may be observed by tapping the Power button
or turn the unit on while the charger is connected. The charging progress will be seen with a charging bar and an
approximate percentage of charge. The ST-5810 can be operated while the batter

2.5 PACKAGE

The ST-5810 comes with the followings:
ST-5810 Universal Signal Level Meter with protective rubber bumper

7.4V/2000mAh Li-Ion battery (installed)

AC to DC power adapter and battery charger 100-240VAC 50/60Hz

USB-C to USB-A data cable

Operation manual

Copyright © 2019-2022 SatLink Elextronics
ST-5810 Operation Manual
Parameter status
Editable fields with popup soft
keypad
13