Advertisement
FITMENT GUIDE
STEP 1 – ATTACH THE BASEPLATE
Remove the boat foot stretcher. Place 1 x nut (D) in one of the 4 hexagonal cavities on the top of the BasePlate. Screw the BasePlate to the foot
stretcher using either screws (B) or (C) depending on the thickness of your foot stretcher. You will need to hold the nut as you screw the screw in
(as shown). Repeat this for all nuts (D) and screws (B) or (C). You will need 4 screws only for each side (leaving you with 8 unused screws B or C).
STEP 2 – ENGAGE YOUR SHOEPLATE TOPS INTO THE BASEPLATE
Line up the ShoePlate Top with the front tab of the BasePlate and place it on top. Slide the ShoePlate Top upwards to engage into the BasePlate,
you should hear a click. Once engaged you should check the ShoePlate Top's tab is fully depressed by pushing down on it. This ensures a proper
locked fitment. Clip on or tie on your FISA approved heel restraints. Repeat for each ShoePlate.
STEP 3 – TO RELEASE
SHOEPLATE TOPS FROM
BASEPLATES
Pull up on the release tab located at the
toe of the ShoePlate Top to unlock it, slide
the ShoePlate Top downwards to disengage
from the BasePlate. You can now clip off or
untie your heel restraints.
YOUR BOAT, YOUR SETTINGS, ANYTIME, ANYWHERE.
FOR FURTHER INFORMATION
PLEASE VISIT OUR WEBSITE
BasePlates
STEERING FOOT ATTACHMENT
The QuickRelease System can
be attached to a steering plate
like a regular shoe. Simply fit the
BasePlates to the steering plate/disc
with the same instructions as above.
BAT LOGIC.
WWW.BATLOGIC.NET
Advertisement
