Table of Contents
Advertisement
Q: How do I replace the backup batteries without losing your settings?
(If old batteries are dead your setting will not be saved)
A: • Remove the power cord and shaker cord.
• Locate the backup battery compartment on the bottom of the unit nd open it with a Philips
screwdriver then remove the cover.
• Plug the power cord in
• Remove old batteries and insert 2 new "AAA" batteries.
• Unplug the power cord.
• Replace the cover. Do Not over tighten the screw.
• Plug the power cord and shaker back in.
• Check to confirm your setting are still saved.
Q: How do I re-sync the shaker in the case of a syncing issue?
A: • Ensure all alarm/alert settings are set to off during
the SYNC process.
• On the Device, Press and HOLD the
seconds to enter SYNC mode, If done correctly,
the LED display will change into Sync mode
• On the Wireless Shaker, while the device is in Sync
mode, reset the Shaker by pressing the reset
button with a small pin (not included), the
Wireless Shaker will vibrate 3 times and the Light
will ash blue to con rm that the device is synced
• On the Device, press the
4
"+" for 7
4
"+" button to exit Sync mode
Sn ooze I D im m er
Alarm
Alarm
Time
26
4
Time
Advertisement
Table of Contents
