capsula JR4 Manual page 6

English
2. Installation in the car (fi g.2)
Fig.2
4
Place the on the car seat, set your child in and secure your child with the lap (O) and diagonal belts
capsula® JR
(N) of the three-point-vehicle-belt. Now fasten the three-point seat-belt with an audible »click« sound (fi g.2). Make sure
that the lap belt runs under the fi xation lugs (C) on both sides and that the diagonal belt leads only under the fi xation
lugs (C) on the side of the belt buckle (Q).
Fig.2.1
Finish the fi xing of the belts by fi xing the belt block anchor (D), only if delivered with. This piece makes sure the diagonal
belt (N) lies fi rmly over the child's shoulder and optimizes the belt guidance. Thread the belt block anchor (D), which is
fi xed on the back side of the seat part, onto the diagonal belt (N) at the height just behind the child's shoulder.
The string to fi x the belt block anchor to the seat must lead behind the back of the child.
Warning:
Do not fasten the belts in any other way than described here, otherwise the child will not be held or secured properly.
Make sure that the diagonal belt is carefully positioned and does not run too close to the child's neck. All belts must lie
fi rmly against the child's body without twisting. If necessary, install a height adjuster mechanism into the car to
correspond to your child's size.
Attention:
This fi xing keeps the booster fi rmly in place in case of the non activated retracting system. Always keep it with the seat
as it avoids injury in case of accident!
7
3. Care Instructions
To wash the seat cover, simply peel it off in an upwards motion. The cover can be washed at 85ºF/30ºC.
Attention: Please do not spin. Do not dry in a dryer.
4. Important Notices
4
• The child seat is approved in accordance to the European
capsula® JR
Standard for child restraint systems ECE R44/04. The test symbol as well as the permit
number can be found on the orange label at the bottom of the seat.
• This child seat can only be used in vehicles with three-point seat-belts, that are approved by
the ECE regulation No.16 or other comparable standards. It is strictly forbidden to install this
seat with the lap belt alone.
• It is not allowed to do any changes on the seat or the belts.
• Each change of any part of the seat, which is not done by the manufacturer, will cause the
expiration of the ECE- approval and excludes immediately any warranties.
• Should any doubts or problems occur, contact your supplier, dealer or
HEYNER MOBIL AUTOMOTIVE GMBH.
• After an accident, the entire child restraint system should be replaced or least sent to the
manufacturer for inspection, together with the accident report. The service cost will be charged.
• Always make sure that the belts only run along the tracks clearly red marked on the child seat
(red belt guide markings).
• Loose or hanging parts of the seat should not be obstructed or restrained by other belts, belt locks
or seats, especially if they change the position.
4
• Always secure the child seat with the vehicle's adult seat-belt,
capsula® JR
even if no child is sitting in.
English
GB
8