NookBox Installation Guide Input and Output Switch DIO-52-ZBS Input & Output Switch (DIO-52-ZBS) DIO-50 is a ZigBee Input and Output Switch. The switch has built-in Digital Input and Digital Output terminals which can be connected to sensor, switch, or devices to form Normal Open (N.O.) or Normal Close loop.
NookBox Installation Guide Input and Output Switch DIO-52-ZBS Parts Identification 1. Function Button / LED Indicator Function Button - Press once to send a supervision signal. - Press and hold for 10 seconds until the LED flash once, then release to reset the Switch.
Page 4
NookBox Installation Guide Input and Output Switch DIO-52-ZBS Features Output Terminal: The output terminal is controlled by the Control Panel; when the Switch receives on/off signal, it will turn on or off the output terminal accordingly. When jumper2 is set to N.C., sending an open/close signal from the Control Panel will open/close the loop. When jumper2 is set to N.O., sending an open/close signal from the Control Panel will close/open the loop.
NookBox Installation Guide Input and Output Switch DIO-52-ZBS ZigBee Network Setup ZigBee Device Guideline: ZigBee is a wireless communication protocol that is reliable, has low power consumption and has high transmission efficiency. Based on the IEEE802.15.4 standard, ZigBee allows a large amount of devices to be included in a network and are coordinated for data exchange and signal transmission.