NookBox Installation Guide Input and Output Switch DIO-52-ZBS Input & Output Switch (DIO-52-ZBS) DIO-52 is a ZigBee Input and Output Switch. The switch has built-in Digital Input and Digital Output terminals which can be connected to sensor, switch, or devices to form Normal Open (N.O.) or Normal Close (N.C.) loop.
NookBox Installation Guide Input and Output Switch DIO-52-ZBS Parts Identification 1. Function Button - Press once to send a supervision signal. - Press and hold for 10 seconds until the LED flash once, then release to reset the Switch. 2. LED Indicator...
NookBox Installation Guide Input and Output Switch DIO-52-ZBS Features Output and Input Terminal • Output Terminal (DO): The output terminal is controlled by the Control Panel; when the Switch receives on/off signal, it will turn on or off the output terminal accordingly.
NookBox Installation Guide Input and Output Switch DIO-52-ZBS • Input Follower: In this mode, the input and output terminals of DIO-52 are connected to separate devices, and the output terminal device will act following the trigger of input terminal device.
Page 6
NookBox Installation Guide Input and Output Switch DIO-52-ZBS Factory Reset If you want to remove the Switch from current network and join a new network, you need to use the Factory Reset function to clear the Switch for its stored setting and information first before it can join another network. To perform Factory Reset: The Switch can only be reset within 3 minutes after power up.
Page 7
NookBox Installation Guide Input and Output Switch DIO-52-ZBS...
Page 8
NookBox Installation Guide Input and Output Switch DIO-52-ZBS...
Page 9
NookBox Installation Guide Input and Output Switch DIO-52-ZBS...
Page 10
NookBox Installation Guide Input and Output Switch DIO-52-ZBS For more information visit: www.getnookbox.com...