UCL SWIFT TEK-4 Training Manual page 23

OPM1
EXAMPLE 2: SINGLEMODE FIBER, POINT-TO-POINT, 2 JUMPERS
Fiber Type
Connectors Used
Test Jumper Setup
OPM Used
OLS Used
FIBER-UNDER-TEST
The fiber-under-test is singlemode with LC connectors on
each end. This method allows testing of connectors inside
bulkheads. One or both ends of this fiber-under-test may
be inside bulkheads. The fiber-under-test may be up to
250 kilometers long. In this example, the fiber-under-test
is 400 meters long.
TEST JUMPER
The test jumpers are both one-meter singlemode fiber.
One has one SC and one LC connector, and the other
has two LC connectors.
POWER METER
The OPM1 power meter is set to the 1550nm
wavelength. The 1310nm wavelength may also
be used. Always match the wavelength on the OPM1
to the wavelength on the LSSM. The adapter on the
OPM1 is the OPAL LC adapter.
LIGHT SOURCE
The LSSM laser source is set to the 1550nm
wavelength. The 1310nm wavelength may also be
used. The adapter is the default OPAS SC adapter.
PAGE 4
Singlemode
LC
(2) Simplex jumpers: (1) SC/LC + (1) LC/LC
OPM1
LSSM
3330 Earhart Drive, Suite 208
Fiber Type
Fiber Type
Test Jumper Setup
Test Jumper Setup
OPM Used
OPM Used
OLS Used
OLS Used
400m Fiber
|
Carrollton, TX 75006
Singlemode
Singlemode
LC
LC
Double
Single
RP 460
RP 460
DLS 355
DLS 355
Connectors Inside
Bulkheads
1m Jumpers
Office: 972.556.0916 Fax: 972.910.8384
| |
The fiber-und
connectors on
be up to 250
fiber-under-te
The test jump
with SC and L
be plugged in
LC connector
fiber-under-te
The
155
wav
mat
to t
ada
ada
The
155
wav
ada