Table of Contents
Advertisement
Additional features
Forced Operation
The operation will be started operation if the power button is pressed without remote controller.
If you want to stop operation, re-press the button.
Cooling Model
Operating mode
Indoor FAN Speed
Setting Temperature
Auto restart
In case the power comes on again after a power failure, the unit operates automatically to the previous
operating conditions.
So there is no need of activating this function by pressing any key or button.
In the initial mode, the fan operates at a low speed and the compressor starts about 3 minutes later.
As the compressor starts, the fan speed also resumes its previous setting mode.
In case of absence for a long time while power failure, turn off main power to avoid
undersired Auto restart.
NOTICE
This feature is enabled by factory default setting, but you can disable it by
pressing the ON/OFF button for 6 seconds. The unit will beep twice and the
indicator lamp(2) will blink 4 times.
To enable it, press the button again for 6 seconds. The unit will beep twice
and the indicator lamp(1) will blink 4 times.
Helpful information
Fan speed and cooling capacity.
The cooling/heating capacity indicated in the specification is the value when
the fan speed is set to high, and the capacity will be lower at low or medium
fan speed.
High fan speed is recommended when you wish to cool/heat the room
quickly.
22 Room Air Conditioner
ON/OFF
button
Room Temp. 24°C(76°F) 21°C(70°F) Room Temp. < 24°C(76°F) Room Temp. < 21°C(70°F)
Cooling
Cooling
High
High
22°C(72°F)
22°C(72°F)
Power button
Heat pump Model
Healthy Dehumidification
High
23°C(74°F)
Heating
High
24°C(76°F)
ON/OFF
button
Hide quick links:
Advertisement
Table of Contents
