Gigabyte GA-6LASH User Manual page 28

19) FP_1 (Front Panel Header)
Connect the power switch, reset switch, chassis intrusion switch/sensor and system status indicator on
the chassis to this header according to the pin assignments below. Note the positive and negative pins
before connecting the cables.
Pin No. Signal Name
The front panel design may differ by chassis. A front panel module mainly consists of power switch,
reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis
front panel module to this header, make sure the wire assignments and the pin assignments are
matched correctly.
Hardware Installation
1 PWLED+
2 5VSB
3 NC
4 ID_LED+
5 PWLED-
6 ID_LED-
7 HD+
8 F_SYSRDY
9 HD- (GND)
10 SYS_STATUS-
11 PWB+
12 L2_ACT
13 PWB+_GND
14 L2_LINK-
15 RST_BTN+
16 SENSOR_SDA
17 RST_BTN_GND
18 SENSOR_SCL
19 ID_SW+
20 CASE_OPEN-
21 ID_SW (GND)
22 L1_ACT
23 NMI_SW-
24 L1_LINK-
Definition
Power LED Signal anode (+)
5V Stanndby Power
No Pin
ID LED Signal anode (+)
Power LED Signal cathode(-)
ID LED Signal cathode(-)
Hard Disk LED Signal anode (+)
System Front board LED Signal
Ground
System Status LED Signal cathode(-)
Power Button Signal anode (+)
LAN2 active LED Signal
Ground
LAN2 Link LED Signal cathode(-)
Reset button Signal anode (+)
SMBus Data Signal
Ground
SMBus Clock Signal
ID Switch Signal anode (+)
Chassis intrusion Signal cathode(-)
Ground
LAN1 active LED Signal
NMI switch Signal cathode(-)
LAN1 Link LED Signal cathode(-)
- 29 -
1 2
23 24